OMC Reed Stop Openings

[Fastjeff57]

Okay, so I'm a Merc guy, but...

Using reeds from an OMC triple (55-65 hp) for a project. The reeds stops don't seem to open all that much, so I'm wondering what openings you OMC guys run (and get away with).

Thanks,

Jeff

[Fastjeff57]

Here's what the homemade reed plate looks like. The reed stops are all bent at different openings, so I need a number to set them all the same to.

[Powerabout]

The manual has a measurment for the tip clearance as I remember it.
Not at home this week but I will post or meaure one when I get home
Ps if that engine is going to make say 90+ hp you would be better off with the 4 reed version from the 2 cyl engine imho?
Cheers

[Fastjeff57]

Love to use the 8 petal reeds, but I have a space problem. The Merc 650/ 700XS motors have the electric starter relocated further aft to allow wider reeds assemblies. The 6 petals will have to do!

Jeff

[Popa Sam]

.280" with steel. .300 with dual stage fiber. Measured from top of bottom reed.

[Fastjeff57]

Thank you!

Jeff