View Full Version : merc guys
Nason
04-23-2014, 09:01 AM
Need help with this problem.
Changed spark plug, gap was preset at 35 and merc requires 40 gap would this make a difference on reading the spark plug color?
Ran motor set at 22 degree 62 jets w/ 3 gallons gas spark plug almost all white with 1 side light tan, would this mean too lean or did not run enough gas to get color on plug? rpm 7000 mph 58.3
Changed jets to 64 made a couple of passes motor ran good until 6500 rpms then stalled a little then came up to 7000 rpms, could this mean too rich speed was 55.5 mph . Spark plug turning a little tanner.
Fastjeff57
04-23-2014, 10:36 AM
Are you running 10 % ethanol gas? The plugs in my inboard (granted it's a 4 stroke) run shockingly white all the time since I was forced to run that stuff.
Jeff
PS: My late and sorely missed buddy ran methanol in his race car (S B Chevy). Plugs were always pure white, and it was jetted perfectly.
Nason
04-23-2014, 12:38 PM
yes with 10 o/o ethanol
Are you running 10 % ethanol gas? The plugs in my inboard (granted it's a 4 stroke) run shockingly white all the time since I was forced to run that stuff.
Jeff
PS: My late and sorely missed buddy ran methanol in his race car (S B Chevy). Plugs were always pure white, and it was jetted perfectly.
dave hensel
04-23-2014, 12:44 PM
Need help with this problem.
Changed spark plug, gap was preset at 35 and merc requires 40 gap would this make a difference on reading the spark plug color?
Ran motor set at 22 degree 62 jets w/ 3 gallons gas spark plug almost all white with 1 side light tan, would this mean too lean or did not run enough gas to get color on plug? rpm 7000 mph 58.3
Changed jets to 64 made a couple of passes motor ran good until 6500 rpms then stalled a little then came up to 7000 rpms, could this mean too rich speed was 55.5 mph . Spark plug turning a little tanner.
Tried & true way of jetting a 2 stroke. Set timing at stock timing. Set stock plugs at stock gap. Warm up engine. Take boat off trailer. Put in brand new plugs. Start engine & go to full throttle. Run about 20 to 30 seconds shut off engine while at full throttle. Check plugs. Tan is best at temperature & humidity. ( I like brown ). Make jet adjustment, put in new plugs and do again. Then play with your timing if you want. Quality of fuel will make a difference here so be carful & read piston.
Fastjeff57
04-23-2014, 04:57 PM
Is it that necessary to use NEW plugs each time?
Mr. Cheapskate
Aeroliner
04-23-2014, 05:17 PM
With our racing program in NBRA where we run 30, 40 and 44 Merc's we found that with 10% ethanol you have to go richer. When we run pure fuel we are at .076" in the KC-6's carbs and with 10% were at .781" for jet sizes. Hope this helps. From the little I know about your setup I assume the plug read shows your lean. You really like to see a dark tan.
Alan
dave hensel
04-24-2014, 05:03 AM
Is it that necessary to use NEW plugs each time?
Mr. Cheapskate
Yes every run.
89HST
04-25-2014, 01:16 PM
jet it until it fourstrokes and go back down 2-4 sizes.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.