OMC gear case

[Gstillwill]

Does anyone know the bearing numbers for the two pinion shart rollers in the OMC A gear case. I have the OMC numbers but need the real bearing numbers. I think the bottom one is a SCE-812 or J-812 but need the top one under the seal.

[Howie Nichols]

George I believe Brian or Bob Trolian know the #'s.

[Skoontz]

If you don't have them by the weekend, I'm going to have one apart Friday or Saturday and will post for you.

[Gstillwill]

Thanks Howie I will call Eddie tomorrow if I can get him. I need to rebuild the gear case on the motor that I loaned Val to run this past weekend and want to make sure I have everything I might need. Its been together for four seasons so I know the water pump has to be ready to go. Thanks Bill if I dont find out the numbers by the time you get yours apart post them. Here are the numbers I know for the other bearings. The two rear bearings are INA number NK-15/16 the one in the brass piece is INA HK-1210 or Torrington J-1210 and one of the pinion shaft bearings are INA number SCE-812 or Torrington J-812

[Gstillwill]

After a few calls I found the number of the last roller bearing. Will not even tackle the thrust bearings they can be got from the Hotrod company. Top pinion bearing is Torington JH-88 and the bottom one is INA SCE-812 the other bearings are in the other post.