Rev limiter

[quty06]

just curious to know,

izzit applied to all outboard engine of yammie,

[Fast Fred]

i only know of one yamaha moda that comes outa the box with no limiter. but you can disconnect the rest of them.:cool:

[quty06]

Thanks for the respon,

i'm goin to ask u a question, is there special wire colour to disconnect for? izzit same colour for all the motor. i'm still green about this all.

[Fast Fred]

white wire, comes out of the box and makes a loop and goes back in, on the older style 40-50hp thares a tang on the back of the box just move it over to off, as in revlimiter off:cool:

[quty06]

this is ON rite..
screw the other site or remove at all to off Rev Limiter?

[Fast Fred]

yes, move it over. them screws can be real tight, can be best to grab them with a set of grips to brake them loose.:cool:

[quty06]

thanks FF, for fast reply

[quty06]

Mine is 40hp 3cyl yammie (1988) outboard,

My Q is How to advance the timing? by mag or flywheel or any other way?

[pr-550yamahadriver]

but with ""hitachi"" CDI

[Fast Fred]

the screw on the bottom of the seesaw controls the max advance.
find TDC and line up the pointer first.:cool:

seesaw= the arm hooked to the mag plate, with the two screws in it, top screw controls the low side or pickup timin. :cool:

[pr-550yamahadriver]

thanks for the info i´ll experiment that

[Fast Fred]

the other style gots a needle on the box, the higher up the needle goes the more timin it brings in. too much timmin is not good.:cool:

[quty06]

the screw on the bottom of the seesaw controls the max advance.
find TDC and line up the pointer first.:cool:

seesaw= the arm hooked to the mag plate, with the two screws in it, top screw controls the low side or pickup timin. :cool:

thanks for the reply,

i'll find out:cool:

[quty06]

but with ""hitachi"" CDI

any recomendation other than this or :confused: