hotsu help

[leehall91]

Well i just baught a slt it is a dux with a mod 50 d hotsu but dont know how to tell if the rev limiter is removed ?Is there a way without tearing the motor apart to tell if the crank has been welded?I was told it was a race preped motor and it has been raced thanks
lee

[Plan-b]

No, you have to take the motor apart to inspect the crank.

[Boatwrx]

If the Black wire with yellow tracer is plugged in forming a loop on the rear of the CDI unit the rev limiter is working. To disable simply unplug it.

Ken Scoville
Boatwrx, LLC
Boulder, CO

[leehall91]

Thanks the rev limmiter is on plugged and looks like the motor has been apart I hope the crank was done when it was apart !The cdi box has dux scribed in it too ?

[Fast Fred]

it can be hard to tell if it's been apart, seen is believin, with the limiter bein plugged in and it sayin dux on it i, myself, would Not believe it.

[Fast Fred]

this is what you want it to look like.:cool:

[leehall91]

Well it has been apart and the rev limiter is unpluged i ran it today and it ran well I will need to rebuild the carbs it has been siting for a year or so any good place to get carb kits? thanks lee

[Fast Fred]

it's not likely that you will need kits, just take them apart, clean them and reassemble, readjust the link and sinc, should be all good.:cool:

[leehall91]

Thanks Fred !!

[Fast Fred]

:cool:

[Fast Fred]

hey Lee, hear a shot of the damper setup i run, the damper it self may be more than you need for your set up, most run a smaller one, but the brackets are the same. there are other setups, but i like mine works for me.